- Ronald Raty
- Posts: 88
25 Mar 2020 20:00 #2656 by Ronald Raty
Replied by Ronald Raty on topic Lifting Locations?
When working on the landing gear, I supported the plane by bolting a couple of 2x4's to the wing mounting bracket to make a stand. I suppose you could suspend from those. That is pretty close to the CG, so the tail shouldn't need much support. When flying, the entire plane is basically suspended on those four bolts.
- Jon Reese
- Topic Author
- Posts: 5
25 Mar 2020 14:45 #2655 by Jon Reese
Lifting Locations? was created by Jon Reese
I have access to an overhead crane and shop where I plan on priming and painting the fuselage (less wings). Has anyone lifted from above before and if so, were did you lift from (points)?
Time to create page: 0.187 seconds