Breadcrumbs

  1. Forum
  3. DIscussions
  5. Tech Help
  7. General
  9. Instrument panel brace factory or not?

Instrument panel brace factory or not?

More
19 Nov 2022 23:55 #1 by Warren Hampton
Replied by Warren Hampton on topic Instrument panel brace factory or not?
Jeff, that is to keep the panel study so the weight of the instr. will not move and vibrate. If you hang your radio tight it would work the sameway I would think!

Please Log in or Create an account to join the conversation.

More
19 Nov 2022 11:25 #2 by Jeff Jones
Replied by Jeff Jones on topic Instrument panel brace factory or not?
Must be factory then. Thanks

Please Log in or Create an account to join the conversation.

More
17 Nov 2022 23:33 #3 by Ronald Raty
Replied by Ronald Raty on topic Instrument panel brace factory or not?
My '46 Ercoupe has a brace just like that one.

Please Log in or Create an account to join the conversation.

More
15 Nov 2022 15:51 #4 by Matt Gunsch
Replied by Matt Gunsch on topic Instrument panel brace factory or not?
Don't know about the mount, but I see fuel drips on the bottom of the header tank.
A&P, IA, PPSEL
too many years GA and Warbird Maint
Check out the Ercoupe Discussion group on facebook

Please Log in or Create an account to join the conversation.

More
15 Nov 2022 15:22 #5 by Jeff Jones
Instrument panel brace factory or not? was created by Jeff Jones
Is this brace factory or add on?  I’m planning  a panel mount com installation and this may be in the way.  It’s a 46 Ercoupe
Attachments:

Please Log in or Create an account to join the conversation.

  1. Forum
  3. DIscussions
  5. Tech Help
  7. General
  9. Instrument panel brace factory or not?
Time to create page: 0.196 seconds
Powered by Kunena Forum