Breadcrumbs
- You are here:
- Home
- Forum
- DIscussions
- Tech Help
- Looking for a set of prints
Looking for a set of prints
- Danny McGee
- Topic Author
30 Jan 2021 15:42 #1
by Danny McGee
Replied by Danny McGee on topic Looking for a set of prints
Mine is 5035
Please Log in or Create an account to join the conversation.
- Matt Gunsch
- Offline
Less
More
- Posts: 453
30 Jan 2021 14:41 #2
by Matt Gunsch
A&P, IA, PPSEL
too many years GA and Warbird Maint
Check out the Ercoupe Discussion group on facebook
Replied by Matt Gunsch on topic Looking for a set of prints
What serial # is your G ? Mine is 5046
A&P, IA, PPSEL
too many years GA and Warbird Maint
Check out the Ercoupe Discussion group on facebook
Please Log in or Create an account to join the conversation.
- Ronald Raty
- Offline
Less
More
- Posts: 208
26 Jan 2021 15:24 #3
by Ronald Raty
Replied by Ronald Raty on topic Looking for a set of prints
Drawings for the 415C can be found here. Many of the parts were the same through all the models.
www.ercoupe.info/mobile/pmwiki.php/Main/Drawings
www.ercoupe.info/mobile/pmwiki.php/Main/Drawings
Please Log in or Create an account to join the conversation.
- Danny McGee
- Topic Author
25 Jan 2021 17:06 #4
by Danny McGee
Looking for a set of prints was created by Danny McGee
I am starting the rebuild of a 415G, looking for a set of prints that identifies the specs of each part mainly the type and thickness of the aluminum used. So I can use the right material to make the part.
Please Log in or Create an account to join the conversation.
Time to create page: 0.092 seconds